About theDIYgeek

theDIYgeek is a maker who learns by researching deeply — and writes the guide they wish had existed before the project started.

Every article here starts from the same place: manufacturer documentation, community knowledge from forums and maker spaces, and published specifications, cross-checked against each other. The goal isn’t to impress you with expertise; it’s to save you the three hours of confused Googling that this project would otherwise cost you.

What you’ll find here

In-depth guides across electronics and microcontrollers, 3D printing, woodworking, smart home, and the occasional repair that started as “this’ll take twenty minutes.” Projects range from absolute-beginner (your first solder joint) to intermediate (your first home server), and every guide says which one it is up front so you never walk into something over your head.

How I write

Sources you can check. Specs come from manufacturer documentation, linked so you can verify them yourself — not from memory, not from vibes. When a guide synthesizes community wisdom, the references are at the bottom.

Honest limits. Every guide includes what the project can’t do and where it goes wrong. A repair trick that only works on certain plastics says so. A solar guide that won’t run your house says so louder. And when a result depends on your specific hardware, the guide tells you to test it rather than pretending there’s one universal answer.

Safety first, every time. Mains electricity, lithium batteries, fumes, spinning blades — when a project touches any of these, the safety section isn’t a footnote, it’s part of the guide. If a shortcut isn’t safe, it doesn’t make the article.

Beginner-friendly without talking down. I assume you’re smart and new, not dumb. Jargon gets explained once, then we move on. No “simply” and no “just” — if it were simple, you wouldn’t need the guide.

What this site isn’t

Not a news site, not a review farm, not a place that publishes ten “best of” lists a week to chase clicks. I publish two or three guides a week, each one researched until I’d feel good handing it to a friend. If the publishing pace seems slow, that’s why — the research is the bottleneck, and I’d rather keep it that way.

Say hello

Found a mistake? Built one of the projects and have real-world results to share? The best thing you can do is leave a comment on the article — that’s how these guides get better. I read every one.

Now go make something.